Direction_finding_connectionless_tx Error

[Quim123]

Good afternoon,

I have started to work with the Direction_finding_connectionless_tx software from Zefyr that you published a few days ago. My intention is to load the AOA mode on a self-designed board that integrates the BL653 module with the nrf52833.

When I load the code I get an error in the function "err = bt_df_set_adv_cte_tx_param(adv_set, &cte_params);", I get the error: "00> Update CTE params...Failed: -35."

I was not able to find the error. Could it be because the software is not suitable for a different platform than nrf52833-DK, or it could be a configuration error?

Thank you very much for your attention.

JP.

[Simonr]

Hi

To update to the master branch you need to follow the "Installing the nRFConnect SDK manually" guide and check out the latest state of development with the following command:

west init -m https://github.com/nrfconnect/sdk-nrf --mr master

During testing on my end, I had no issues with detecting the advertising device when using a DK, so there might be some board configurations required to use the board you have. I don't think there are any other defines that need to be modified to get it up and running.

Best regards,

Simon 

[Quim123]

Thank you very much for your reply but I have not been able to solve the problem yet.

I have been able to download and use the latest version and I keep getting the same error, I have followed the installation process of the SDK version and I can't find the error. I have tried to complete the project with the nrf52833dk_nrf52833 board and I get the attached errors. Could it be a configuration error of the Segger embedded Studio? how should it be configured?

Thank you very much for your attention.

JP.

.

[Zack_Lee]

Hi Quim123,

you may change to a clean environment ( new computer or reformat ) for those command setup, as i had met this issue before. It seems that python command is not yet complete.