Get Value on nrf51822ek slave on central and display on terminal

[Mohib]

I am getting device id of peripheral on central and then getting it displayed on hypertermianl hyperterminal using ble app multilink perihperal code with multilink central on nrf51822 ek each. The data received on hyperterminal is shown below

Now I wanted that when i press a button on slave , its Value should toggle and display on hyperterminal. Currently, this Value is displayed on MCP of dongle, as shown below but not anywhere in the hypertermial. How can i get this to be displayed on hyperterminal ?

Any sort of help is appreciated..

[Hung Bui]

@Mohib: If you simply want to forward a button press on a nRF51822 ek to another embedded board ( in your case the Raspberry PI ? ) would it's be better to use another nRF51822 as a central device (instead of the dongle) and output it to GPIO pin ?

[Mohib]

m using another 51822 board as central, dongle is just for testing. from central , data is sent to pi

[Hung Bui]

@Mohib: If your plan to use nRF51822 as central, I guess you can go straight to that and try to connect the nRF51 with the Raspberry PI via SPI, UART or I2C.

If you really want to test with the dongle, you can think of using the Master Emulator APIs, instead of using the Master Control Panel. The Master Emulator APIs could be found at C:\Programfiles(x86)\Nordic Semiconductor\Master Emulator.

We have some examples in that folder as well.

[Mohib]

i think i may be unable to explain my point to you. in simple, i want to send value of a salve kit button whenever it is toggled, on central. The value highlighted in the pic , i want that on my central and display on terminal. I am getting some data on termial using ble_app_multilink_peripheral and central code but not the value of button

[Hung Bui]

@Mohib: could you explain more on " I am getting some data on termial using ble_app_multilink_peripheral and central code but not the value of button" ? Which data have you got ?