MFW 1.3 Reset Loop

[Thomas]

Hi,

Is there a way to turn off the reset loop detection on MFW 1.3? It's annoying having to wait half an hour when you are developing...

Kind regards,

Thomas

[Heidi]

Hi!

No there's no way to disable the feature. You can get out of the reset loop by running AT+CFUN=0.

Correction: there is no way to get out of the reset loop either. 

However, if the user cuts power without the modem in offline mode (+CFUN=0), the restriction timer starts all over again in the next power-up. 

Best regards,

Heidi

[Thomas]

Thank you Heidi,

I've tested and this does not get you out of the loop, it only does so if you wait the half hour?

[Heidi]

Hi,

Please note that the restriction time does not elapse if there is no power in the device.

Are you turning off the device at any point in the reset loop?

[Thomas]

Sorry my misunderstanding, I thought you were saying you could cut the half hour short by issuing AT+CFUN=0. 

Might I suggest that in future versions this feature can be disabled/enabled until %XPRODDONE is set?

[Heidi]

Hi, I misunderstood as well. I have edited my initial comment.

There is no way to turn off the reset loop detection feature nor to go around it. 

I will suggest this to the team for future MFW releases.

Best regards,

Heidi