Hi! I'm using the nRF Sniffer software (Windows 1.0.1 Rel.1111) with nRF51-DK Board (Rev. 1.1.0) and Wireshark (1.12.5). Everything works fine until the number of 65535 (0xFFFF) captured packets is reached. In the log.txt lost packets are reported before reaching "the end" than transmission stops with several "INFO: UART read timeout (2 seconds)." messages.
Exerpt from log:
12-Jun-2015 11:40:45 ERROR: Invalid packet: packet list not valid: [6, 41, 1, 155, 206, 6, 10, 1, 31, 79, 74, 102, 150, 0, 0, 0, 103, 50, 173, 222, 10, 21, 0, 17, 0, 4, 0, 29, 41, 0, 170, 33, 0, 0, 0, 158, 0, 0, 0, 10, 21, 0, 17, 0, 4, 0, 29, 41, 0, 170, 33, 0, 0, 0, 160, 0, 0, 0, 0, 54, 90, 14, 0, 177, 138, 37]
12-Jun-2015 11:40:45 INFO: gap in packets, between 52890 and 52900 packet before: [6, 19, 1, 154, 206, 6, 10, 11, 31, 46, 74, 102, 179, 37, 0, 0, 103, 50, 173, 222, 13, 0, 165, 65, 70] packet after: [6, 24, 1, 164, 206, 6, 10, 3, 22, 45, 79, 102, 50, 37, 0, 0, 103, 50, 173, 222, 2, 5, 1, 0, 4, 0, 30, 45, 137, 144]
12-Jun-2015 11:41:48 INFO: gap in packets, between 65535 and 0 packet before: [6, 19, 1, 255, 255, 6, 10, 11, 15, 46, 2, 127, 178, 37, 0, 0, 103, 50, 173, 222, 13, 0, 165, 65, 70] packet after: [6, 40, 1, 0, 0, 6, 10, 1, 15, 63, 2, 127, 150, 0, 0, 0, 103, 50, 173, 222, 10, 21, 17, 0, 4, 0, 29, 41, 0, 170, 33, 0, 0, 0, 250, 0, 0, 0, 0, 62, 81, 15, 0, 78, 72, 211]
12-Jun-2015 11:41:53 INFO: UART read timeout (2 seconds).
12-Jun-2015 11:41:55 INFO: UART read timeout (2 seconds).
12-Jun-2015 11:41:57 INFO: UART read timeout (2 seconds).
[...and so on...]
Tested on different computers (all Windows 7) and different USB-Ports. Same results.
Is this a limitation in soft- or hardware or just a bug that might be fixed?
