Application won't run, unable debug

[gaminn]

Hi, I'm unable to run any application on nrf51 DK (Keil used). When I start debug (no matter what application I load), program always cycles between 2 instructions:

0x000006CC BF20 WFE
0x000006CE E7FD B 0x000006CC

This happens even when blinky example is loaded.

Previously everything worked until I made a program which generated hard fault. After that I'm unable to run/debug any application. But I'm not sure whether that hardfault is the cause of the problem.

[Susheel Nuguru]

post your code where this happens, most probable reason seems that your application goes in sd_app_evt_wait(). I cant understand why blink example has WFE instruction in it?

[gaminn]

Thanks for your reply. My application is blinky example from current nr51 SDK run on nrf51 DK. Blinky code I ran full chip erase, then load the blinky application.