Problem adding I2S to nRF connect SDK - DTS

[HyperS]

Hi there,

First of all; I have experience in Keil but I am new to SEGGER and Zephyr.

Rebuilding our project in Segger using the new nRF Connect SDK I am stuck at adding I2S to an example.

I started with the Nordic NUS (BLE UART) example, which runs OK at my board.

I started adding I2S to the project using 'Configure nRF Connect SDK Project", enabling 'Enable I2S driver <NRFX_I2S>' and 'I2S bus drivers <I2S>'.
After configuration, result OK, I added a label to the dts overlay.

&i2s0 {
compatible = "nordic,nrf-i2s";
};

After I run CMake I get the error 'create_nordic_project.py failed (1).
The error output says:
Error: nrf52dk_nrf52832.dts.pre.tmp:500.1-6 Label or path i2s0 not found

I think I can get it working 'the old way' but I want to switch to the DTS system for now.

Anybody got a lead for me?

Thanks,

Sander

[HyperS]

Addition:
Using: SEGGER Embedded Studio - Release 5.34a  Build 2021011401.44914
nRF Connect SDK V1.5.1
Example used: ncs\v1.5.1\nrf\samples\bluetooth\peripheral_uart

[Håkon Alseth]

Hi,

 

Unfortunately, the i2s isn't ported to zephyr yet (no "nrf" port here: https://github.com/zephyrproject-rtos/zephyr/tree/main/drivers/i2s), so you have to use the nrfx driver directly.

There's a sample available here, but this is tailored towards nrf5340:

https://github.com/siguhe/NCS_I2S_nrfx_driver_example

 

But I have also ported a sample from nRF5 sdk:

ncs_nrf5_i2s_sample.zip

 

Kind regards,

Håkon

[HyperS]

Hello,

Thanks for your answer!
It seems that I finally got your port to work, I will check with a Logic Analyzer tomorrow.

However, it seems to hang on:

 do {
			k_cpu_idle();

            if (mp_block_to_fill)
            { 
                printk("1\n");
                prepare_tx_data(mp_block_to_fill);
                mp_block_to_fill = NULL;
            }
            printk("2\n");
        } while (m_blocks_transferred < BLOCKS_TO_TRANSFER);

The debugger prints 1,2,1,2 forever it seems.

Does it need a slave just as I2C to function?

Thanks,

Sander

<EDIT 17-06-2021> m_blocks_transferred is never increased. I added an increase but I'm not sure if it was placed in the right place. I added: m_blocks_transferred++; after: prepare_tx_data(mp_block_to_fill);.

[Håkon Alseth]

Hi,

 

HyperS said:

<EDIT 17-06-2021> m_blocks_transferred is never increased. I added an increase but I'm not sure if it was placed in the right place. I added: m_blocks_transferred++; after: prepare_tx_data(mp_block_to_fill);.

 Ooops! I cut away a bit too much when I ported the project, my apologies!

Your proposed fix is good.

 

Kind regards,

Håkon