This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

High drive & QSPI pin on nRF52840

Hello, 

In a design we plan to have 2 x SPI, 1 x QSPI and 1 x I2C interface. For the SPI we plan to use one @32MHz and the other @8MHz.

Please confirm there no "instance issue" with all these interfaces ?

Could you also please confirm that High drive pins (-> for 32Mbits SPI) are those where nothing is written in the "recommended usage" column.

For some pins it is written "Standard drive, low frequency I/O only" so I assume that others GPIO can be configured as High drive.
For QSPI we plan to use the recomended ones (P0.18, P0.19, P0.21 - P0.24)

Thanks and have a nice week-end

Best regards

Nicolas

Parents Reply Children
Related