ZCL Subscription no event sending up

[KLLiew]

Hi,

I'm using nRF5 SDK, use original build. No change anything. Just enable the Zigbee CLI as Coordinator.

After tested with various devices, found out a lot devices, after subscribe did not sending up any event. not sure is device or SDK issue.

Tested with nRF52833 DK as coordinator.

Device 1 - 3 Gang Wall Switch (with Neutral) - Working fine.

Device 2 - 3 Gang Wall Switch (without Neutral) - Success subscribe, but no event sending up.

Is this known issue?

Best Regards,

Alan

[Marjeris Romero]

Hi Alan,

For 'zcl subscribe on' cmd to work you need to subscribe to an attribute that supports attribute reporting. You can check if an attribute is reportable or not in the Zigbee ZCL specification.

Best regards,

Marjeris