SPI clock pin configuration for nRF52840.

[Shivek]

Hi,

I am using nRF52840 on custom board. I am trying to configure SPI pins, but I am not getting anything on the clock pin. I can see the chip select pin going low and high which is good. But there is no clock on the pin. Following is the code snippet from my project.

#define MEM_CS                           NRF_GPIO_PIN_MAP(0,4)
#define MEM_SI                           NRF_GPIO_PIN_MAP(0,7)
#define MEM_SO                           NRF_GPIO_PIN_MAP(1,8)
#define MEM_SCK                          NRF_GPIO_PIN_MAP(0,13)

void memInit(void)
{
	    //GPIO configuration
        nrf_gpio_cfg_output(MEM_CS);
        nrf_gpio_cfg_output(MEM_SI);
        nrf_gpio_cfg_output(MEM_SCK);
        nrf_gpio_cfg_input(MEM_SO, GPIO_PIN_CNF_PULL_Pulldown);

                
        //SPI configuration
        nrf_drv_spi_config_t spi_config = NRF_DRV_SPI_DEFAULT_CONFIG;
        spi_config.ss_pin    = MEM_CS;
        spi_config.miso_pin  = MEM_SO;
        spi_config.mosi_pin  = MEM_SI;
        spi_config.sck_pin   = MEM_SCK;
        spi_config.bit_order = NRF_SPI_BIT_ORDER_MSB_FIRST;
        spi_config.frequency = NRF_SPI_FREQ_250K;
        spi_config.mode      = NRF_SPI_MODE_2;
        
        nrf_drv_spi_init(&spi, &spi_config, spi_event_handler, NULL);

}

uint32_t memId()
{
        __disable_irq();
        
        nrf_gpio_pin_clear(MEM_CS);         //Pin goes low now

        err  = nrf_drv_spi_transfer(&spi, p_tx_buffer, sizeof(tx_buffer), NULL, 0);  
        nrf_delay_ms(100);
        
        nrf_gpio_pin_set(MEM_CS);           //Pin goes high now

	    __enable_irq();
        return err;
}

For my custom board configuration I have set Preprocessor definitions to BOARD_CUSTOM. But for simplicity, I have defined the pins in the source code file. I am thinking to test it first and then I can define the pins for SPI in custom_board.h. On the custom board I have checked for the pins they are not connected to any other peripheral. 

For development, I am using SES with nRF SDK15.0.0 and Softdevice S140. 

Any insight would be appreciated.

Thanks!

[Shivek]

I forgot to add the event handler code so to explain further, here is the code for event handler function:

void spi_event_handler(nrf_drv_spi_evt_t const * p_event,
                       void *                    p_context)
{
    printf("\r\n Error : %ld", err);
}

Every time I am calling, memId I can see the chip select pin (MEM_CS) goes low and high. The delay in memId funciton is just for testing purpose. So, I can see the Error being printed as "0", that means the nrf_drv_spi_transfer() returns successfully. This is confusing me.

Looking forward for any help.

[Shivek]

So, finally I was able to see the clock and signal. The Problem was disabling the interrupts before calling the transfer function and this discussion helped me to configure SPI driver properly. Thanks to Hmolesworth and Einar.