Development control software for nRF53 radio configuration and control

[Mike C]

When using the nRF52 I was able to program the device with a special test build which allowed me, via a simple CLI, to control the radio and set a channel, vary power, set modulation etc. This was extremely useful as it enabled me to carry out measurements etc on the radio PHY.

Is there any such control software for the nRF53?

On searching for this I have returned a blank, so I am turning to this support channel to see if anyone else has the same problem.

If this is not available yet then Nordic, when are you going to develop this useful tool?

Thanks.

[Marte Myrvold]

Hi,

We have the Radio test sample in NCS which allows you to send commands to the device and configure the radio. This sample is supported on the nRF5340 DK.

Best regards,

Marte

[Mike C]

Many thanks for the prompt response, I will take a look at this.

Regards,

Mike