• State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 62 subscribers
  • Views 1307 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 107779
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

MCP default values

Dani

Now I'm working with MCP 3.9.0. When any device is connected, characteristic default values are not 0's. Can they be initialized in any way? It is a little bit annoying when certain values have to be written in order to be sent to remote device, because all bytes have to be set to 0 before. Best regards.

Parents
  • 0

    I mean that it should be great that characteristic values that appear by default were 0. Now, when my module is connected, there are only-write characteristics that appear as I show here below, while in previous versions of MCP, all values were 00-....-00 by default: 91-00-40-00-FE-FF-09-00-7F-E7-01-02-FF-ED-24-03-FF-97-DF-BB

Reply
  • 0

    I mean that it should be great that characteristic values that appear by default were 0. Now, when my module is connected, there are only-write characteristics that appear as I show here below, while in previous versions of MCP, all values were 00-....-00 by default: 91-00-40-00-FE-FF-09-00-7F-E7-01-02-FF-ED-24-03-FF-97-DF-BB

Children
No Data
Related