Serial Port 3

[saeed mahvis]

Hi

thank you very much for your paying attention.

Yes the peripherial_uart sample seems to be a good choice for my project. But Uart 0 pins didn't come out on GPIO connector 

pins in NRF5340-DK development board. Can I use Uart 1 instead of Uart 0 in the peripherial_uart sample and if it is possible what is 

the logic level I should use 5v or 3.3v?

[Øivind]

Hi,

Please do not open a new ticket for each response.

Please respond to this ticket: https://devzone.nordicsemi.com/f/nordic-q-a/78271/serial-port-2

Below Sigurd's message you will find a "Reply" button. Click that and type in your response, then click "Reply".