Unable to detect node in nRF MESH app after flashing code into BL653 kit

[pavani]

Hello Nordic Team,

I am trying to flash the existing BLE light example code to my BL653 kit with Segger Embedded Studio. After falshing the code into the board it is taking some time to give the ouput. The node is not getting detected in the nRF mesh app. can you suggest which sample code need to be added to get detected on the nRF mesh app

Thankyou!

[pavani]

I am using nRF connect sdk v1.6.1 version. I am reffering to the mesh light example from nRF connect sdk.just i have done debug and flashed the codebinto the BL653 kit. Still i am unable to see the device in nRF mesh app in my mobile. Ihave 32khz crystal on my board. Can u suggest which extra code need to be added so that device can be detected in the nRF mesh app

[Mttrinh]

Hi,

No extra code should be necessary for it to be detected in the nRF Mesh app. Have you made any modifications to the example other than adding your board?

Can you also use the nRF Connect app for mobile to see if you can detect it there? This is just to check if the device is advertising at all.

[pavani]

now i am able to detect the node successfully

[Mttrinh]

Glad it worked out for you.