Generate NCP firmware for UART with UART pins modified

[Bhumika]

I am using Nordic's NRF_SDK_For_Thread_and_Zigbee_4.1.0.

In that example/thread/ncp, I want to build NCP firmware for uart.

Original uart pins for rx and tx are 8 and 6.

While I want to build that firmware for pins 26 and 6.

UART Rx is 26 and Uart Tx is 4.

So where I should update these pins so that my custom nordic module, that has uart Rx on 26 and Tx on 4, can be interfaced with my custom gateway board, which I use as border router.

Also, should I add some Pullup or Pulldown to Rx pin in the NCP's main code?

nrf_gpio_cfg_input(0x1A, NRF_GPIO_PIN_PULLUP);

[Bhumika]

Thanks for the reply. I will do this step and let you know.