• State Verified Answer
  • Replies 20 replies
  • Subscribers 87 subscribers
  • Views 5530 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 275882
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nrf52840 DK is not Detecting in nrfConnect with PC.

Soham Mistry

Hello to all,

I have a problem with nrf52840 DK board, it was not detecting in nrfConnect with PC.

Previously it was working but when I had checked one sensor which is I2C based. Once it appears in port and after some time when I had plugged it in my PC there is no detection of the board in my system. 

Also, LED5 is not blinking and USB cable is also good.

I had tried to connect the board through USB by pressing IF/BOOT but then also it doesn't work.

Please suggest some solution for this.

Thanks in Advance.

Regards 

Soham Mistry

Parents
  • 0

    Hello, 

    Previously it was working but when I had checked one sensor which is I2C based. Once it appears in port and after some time when I had plugged it in my PC there is no detection of the board in my system.

    Can you please elaborate more on what you mean with "it was working but when I had checked one sensor which is I2C based"? 

    What application are you running on the DK? What operating system are you using?  

    Thanks. 

    Kind regards,

    Øyvind

Reply
  • 0

    Hello, 

    Previously it was working but when I had checked one sensor which is I2C based. Once it appears in port and after some time when I had plugged it in my PC there is no detection of the board in my system.

    Can you please elaborate more on what you mean with "it was working but when I had checked one sensor which is I2C based"? 

    What application are you running on the DK? What operating system are you using?  

    Thanks. 

    Kind regards,

    Øyvind

Children
No Data
Related
Terms of service