nrf52832 mesh and __LOG over UART

[L.B.]

Hello everyone!

I'm using nrf5_SDK_for_Mesh_v5.0.0_src and I'm trying to run the Serial example. I see no Bluetooth advertising so I wanted to redirect __LOG to UART.

However I read this post:

https://devzone.nordicsemi.com/f/nordic-q-a/25142/mesh-example-debug-print

Could anyone confirm if this feature is supported or not in version v5.0.0?

Regards,

L. B.

[Simonr]

Hi

Yes, you need to use the files from the nRF5 SDK (v17.0.2). Please check out the Getting started guide, and specifically the first time setup for SEGGER Embedded Studio where you can set up the SDK_ROOT macro in SES to find the required nRF5 SDK files.

Best regards,

Simon

[Mttrinh]

Hi,

Have a look at this and this.