• State Verified Answer
  • Locked Locked
  • Replies 11 replies
  • Subscribers 89 subscribers
  • Views 2891 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 278542
Options
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

The nRF sniffer - Wireshark not listing the Interface

Dil

Hi,

I'm using Windows 10, Wireshark 3.2.17, python 3.9,   pyserial 3.5.

I see this question has been asked before but the solutions did not work for me.

I get the following output to verify the extcap.

I only have one python version (3.9) installed and pyserial is installed for that.

From wireshark I can enable, View -> Interface toolsbars-> nRF sniffer for 802.15.4. 

Still I do not get the interface listed in Wireshark to capture. Wireshark can capture packets from other interfaces.

I use the nRF52840-DK board programmed with .hex file via nRF Connect.

Next, I also tried to see with ble sniffer, but the interface does not get listed for that either.

What am I missing?

Parents
  • 0

    Hi Simon,

    I have done the configuration for Zigbee and adding keys. I had followed the instructions before. 

    This time I did the 'Erase all' -> 'Erase & Write' and then opened wireshark but still the interface is not listed. I refreshed the interfaces as well but still it did not get listed.

    Is there any way I can debug what is wrong? 

Reply
  • 0

    Hi Simon,

    I have done the configuration for Zigbee and adding keys. I had followed the instructions before. 

    This time I did the 'Erase all' -> 'Erase & Write' and then opened wireshark but still the interface is not listed. I refreshed the interfaces as well but still it did not get listed.

    Is there any way I can debug what is wrong? 

Children
No Data
Related
Terms of service