• State Verified Answer
  • Locked Locked
  • Replies 11 replies
  • Subscribers 89 subscribers
  • Views 2891 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 278542
Options
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

The nRF sniffer - Wireshark not listing the Interface

Dil

Hi,

I'm using Windows 10, Wireshark 3.2.17, python 3.9,   pyserial 3.5.

I see this question has been asked before but the solutions did not work for me.

I get the following output to verify the extcap.

I only have one python version (3.9) installed and pyserial is installed for that.

From wireshark I can enable, View -> Interface toolsbars-> nRF sniffer for 802.15.4. 

Still I do not get the interface listed in Wireshark to capture. Wireshark can capture packets from other interfaces.

I use the nRF52840-DK board programmed with .hex file via nRF Connect.

Next, I also tried to see with ble sniffer, but the interface does not get listed for that either.

What am I missing?

Parents
  • 0

    Hi,

    I have attached a screenshot of the wireshark window, after doing the following.

    1. Capture -> Refresh Interfaces

    2. Enabling View -> Interface Toolbars -> nRF sniffer for 802.15.4

    At this point a full erase and write was done to the DK board. Other configurations such as keys in wireshark is also done. As in the image, the interface is not listed.

    Thanks in advance!

Reply
  • 0

    Hi,

    I have attached a screenshot of the wireshark window, after doing the following.

    1. Capture -> Refresh Interfaces

    2. Enabling View -> Interface Toolbars -> nRF sniffer for 802.15.4

    At this point a full erase and write was done to the DK board. Other configurations such as keys in wireshark is also done. As in the image, the interface is not listed.

    Thanks in advance!

Children
No Data
Related
Terms of service