BL653 Bootloader? Need to Reload?

[DavidTroike]

i am using Laird smartBASIC for my programming of the BL653.  I cloned the firmware of the evaluation board using the supplied Laird batch files and the J-LinkARM interface.  However I did not use the batch files to load the firmware using a JTAG SWD interface to my target board.  I used the Segger J-Flash program and a J-Link loading the merged firmware and application hex file.  In doing so I erased the bootloader of the nRF52833.  I am assuming that is what I happen when programming. The J-Link erased the chip completely and loaded the hex file starting at the lowest address.  This is my assumption at least.

Where do I get the bootloader and how would I restore it?

I am new to ARM programming, Laird Products, and especially the nRF52833 product. 

[Jared]

Hi,

This question should be directed to Laird who provides the specific bootloader. Try the Laird forum.

regards

Jared 

[DavidTroike]

Thanks, was not sure where to go.  I reached out to Laird Tech Support but they have not had the chance to get back to me.