SDK7.1 keypad connect ubunt14.4 success!

[Sr Huang]

I try to use SDK8.1.1 example connect ubuntu14.4 with CSR dongle. Seems it create connection fail. I downgrade to SDK7.1, it connection pair correctly. But it'll terminate connection once finish pair.

Here is hcidump

HCI Event: Number of Completed Packets (0x13) plen 5 handle 63 packets 1 ACL data: handle 63 flags 0x02 dlen 10 ATT: Read By Type resp (0x09) length: 4 handle 0x0005, value 0xc1 0x03 < HCI Command: Disconnect (0x01|0x0006) plen 3 handle 63 reason 0x13 Reason: Remote User Terminated Connection HCI Event: Command Status (0x0f) plen 4 Disconnect (0x01|0x0006) status 0x00 ncmd 1 HCI Event: Disconn Complete (0x05) plen 4 status 0x00 handle 63 reason 0x16 Reason: Connection Terminated by Local Host

WireShark have same result. It also indicate Host terminate connect reason 0x13.

[Stian Røed Hafskjold]

I tried now with SDK 8.1, ubuntu 14.04, bluez 4.101-0ubuntu13.1 and the CSR dongle, and I didn't have any problems connecting. Which tools and commands do you use to connect?

Make sure you delete any bond info. In the terminal write:

bluez-test-device remove xx:xx:xx:xx:xx:xx

Then I did the following to connect and enable notifications:

gatttool -b xx:xx:xx:xx:xx:xx -t random -I

> connect
> sec-level high
> char-write-req 0x0017 01

EDIT:

The reason why it disconnects while holding down button 0 is because connection_buttons_configure() in bsp_btn_ble.c configure a long push on button 0 to disconnect.

#define BTN_ID_DISCONNECT  0;  
#define BTN_ACTION_DISCONNECT  BSP_BUTTON_ACTION_LONG_PUSH

connection_buttons_configure() is called in the function bsp_btn_ble_on_ble_evt() whenever the BLE event says BLE_GAP_EVT_CONNECTED. This is a part of the bsp library, but I agree that it doesn't go along well with the hids demos since you push the buttons a lot in the demos. You can simply set the BTN_ID_DISCONNECT define to something else than the 4 buttons, and it will not bother you anymore.

When it comes to Linux not being able to reconnect, I'm not sure what the problem is. I am not able to reproduce the error here. I've tried with Bluez 4 and 5, Ubuntu and Debian, as well as Android. What I noticed was that in Bluez 5, if I wrote the connect command before the pair command, I had troubles getting Linux to recognize it as a HID device. So, in bluetoothctl I just wrote pair XX:XX:XX:XX:XX:XX without connecting first.

[Stian Røed Hafskjold]

I'm using the same version of bluez. It is the ble_app_hids_keyboard example you are using right? Can you please post the hex-file so I can try it here?