NRF52833+NRF24LE1 2.4G

[nbyte]

Hi

Nordic Team

I use ncs1.6.0, SES compiler.I have a very difficult problem:

Now I am debugging the 2.4g communication between NRF52833 and NRF24LE1. I set the rate, data length, address width and address content to be the same, but failed. What else should I pay attention to?

I am looking forward to your reply. 

thank you very much

[run_ar]

Hi,
Are you configuring the radio directly? or are you using our ESB library? Anyway, I would recommend you take a look at our ESB library, and check the backward compatibility setting (i.e. take a look at what this define actually do in the library)

[nbyte]

Hi,

Thank you for your reply. I have found the cause of the problem. I use the ESB library, but only ESB_PROTOCOL_ESB when configuring ESB_protocol. I previously selected ESB_PROTOCOL_ESB_DPL, so it was never successful.

thanks