pin voltage on SPI bus mcp2515

[T.B-D]

Hi.

i see that ther are democode in zephyr that use the can shield DFRobot CAN bus V2.0

https://developer.nordicsemi.com/nRF_Connect_SDK/doc/1.7.1/zephyr/samples/drivers/can/README.html

In the schematic i see that the mcp2515 and tja1050 chip are driven by 5 volt.
I asume that this give 5 volt on the spibus pin 12-16 can the nrf9160 handel this 5 volt ?

chrome-extension://efaidnbmnnnibpcajpcglclefindmkaj/viewer.html?pdfurl=https%3A%2F%2Fwww.dfrobot.com.cn%2Fimages%2Fupload%2FFile%2FDFR0370%2F20160406125424bsw8e2.pdf&clen=83360&chunk=true

[Jared]

Hi,

VDD_GPIO on the nRF9160 can be configured to maximum 3V6. Which means that 5V0 is not supported and can damage the board. Consider using a level shifter. 

regards

Jared