• State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 73 subscribers
  • Views 1807 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 108257
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Nordic NRF51822 flashing

nagaraj

Dear all We did nordic beacon board in that we not able to flash the device We are checked core voltage 1.2V and 1.7V are coming .But i want to confirm external CLOCK will generate before code is flashing or after code is flashed then only this clock can turn on.

Regards naga

  • 0

    Dear All I am facing issues on nRF51822 nordic chip We make Pcb with chip antenna (W3008 ) .We are flashed the our beacon code . The device is no detected .Could you please me the issues I am attaching the my schematic and board files nrf51822-pcb.JPG

    Layer Stack up layer 1 top components layer 2 ground layer 3 power layer 4 Bottom Board thickness 1.6mm ST balun chip balu chip output track width is 25 mils
    Please give me your commands on this issues

  • 0

    Hi,

    Have you tried connecting a spectrum analyzer to the output of the balun? Also where is your pi-network to match the chip antenna to 50ohm? Please see the general PCB design guidelines, it contains a lot of useful information on designing your layout.

Related
Terms of service