Issue with NRF_TWIM_TASK_STOP and NRF_TWIM_EVENT_STOPPED on NRF52833 DK

[scath]

Issue:

While trying to initialize and check the viability of an I2C interface using TWIM, my NRF_TWIM_TASK_STOP never triggers NRF_TWIM_EVENT_STOPPED.

Code:

nrf_twim_task_trigger(reg, NRF_TWIM_TASK_STOP);
while (nrf_twim_event_check(reg, NRF_TWIM_EVENT_STOPPED) == 0) {
    printf("IN WHILE WAITING FOR (NRF_TWIM_EVENT_STOPPED == 1)\n");
}

This causes the "IN WHILE" message to print indefinitely.

Wondering how I can verify that the trigger is being pushed to the correct address, and diagnose why the event is not getting fired.

Cheers!

[Jørgen Holmefjord]

Hi,

I'm not sure if triggering the STOP task when the TWIM peripheral is not enabled/configured will generate any STOPPED event, as it is not in the proper state. From the TWIM peripheral documentation:

"The TWI master is stopped by triggering the STOP task. This task must be triggered before the NACK bit is supposed to be transmitted. The STOP task can be triggered at any time during the reception of the last byte. It is recommended to use the shortcut between LASTRX and STOP to accomplish this.

The TWI master cannot be stopped while suspended, so the STOP task must be issued after the TWI master has been resumed."

You can also see from the transfer sequence diagrams in the documentation that the STOPPED event is first generated after the STOP condition have been generated on the TWI bus.

Your application should be able to know if you have configured an TWI instance or not, is there any other way you can keep track of whether the instance is in use or not in your application? 

Best regards,
Jørgen

[scath]

Hi Jorgen,

Apologies for the missed diacritical in your name ;)

The method I've been asked to work on probes a sequence of addresses and is meant to return any address that can perform all of the basic twim tasks.

The sequence of method calls (in pseudo-code, minus params) are as follows:

nrnf_twim_enable
nrf_twim_address_set
nrf_twim_tx_buffer_set(reg, NULL, 0) // blank the buffer

nrf_twim_task_trigger-> NRF_TWIM_TASK_RESUME
nrf_twim_task_trigger-> NRF_TWIM_TASK_STARTTX

while NRF_TWIM_EVENT_TXSTARTED == 0 && NRF_TWIM_EVENT_ERROR == 0 print warning to console

nrf_twim_event_clear -> NRF_TWIM_EVENT_TXSTARTED

nrf_twim_task_trigger-> NRF_TWIM_TASK_STOP

while for NRF_TWIM_EVENT_STOPPED == 0 print warning to console

More code follows, but the method hangs on that last check - it never moves past the while.

Curious if the calls are out of order here.

Thanks so much!

S.