Reconnecting with bonded device without the advertising process

[Raghu GS]

Hi everyone,

We are making a BLE peripheral that measures some data and keeps it ready for the mobile phone to connect & poll the data. The data should be private and available only to the bonded phone. Upon powering on for the first time, device will be advertising and visible to anyone. The Master control panel then connects & bonds with the device. After this, the device is whitelisted only for the bonded master control panel. Problem is, when the connection breaks, in order to reconnect with the device again through the master control panel, we have to start advertising from the device which will eat up a lot of battery.

Is there any way for the master control panel to connect with a bonded device without the need for the device to advertise?

Or is there any other technique which will enable the master to try & connect to the device without any knowledge of whether the device is within range or out of range?

[Petter Myhre]

A central cannot connect to peripheral if it isn't advertising. The central wouldn't know when to send the connection request, and the peripheral wouldn't know when to listen for the connection request.

If you want to reconnect because of an unintended disconnection, it shouldn't be necessary to advertise for very long, as long as the central is scanning at the same time.

If you are talking about the general case when the peripheral doesn't know when the central will scan, you will need to make a choice between fast connection (shorter advertising interval, draining more current), slow connection (bigger advertising interval, draining less current), or something inbetween.

As David mentions, if you want to connect without advertising you need to change the roles, become a central where you are scanning instead of advertising, but scanning usually drains more power, so...

[Petter Myhre]

Depends on what setting you have set in the app. Go to Settings->Scanner. Then you should have continous scanning enabled and the scanning mode should be Low Latency. Other than that, it is little you can do, unfortunately.