how to remap pin(pin 0 & pin 1) port 0 to gpio

[VADIM KADUKOV]

On the nRF5340  P0.00 and P0.01 are used for the 32.768 kHz crystal by default and are not available as GPIO on the connectors.

how to remap  this pins to gpio? 

[Priyanka]

Hi,

 The 32.768 kHz crystal can be disconnected and the pins can be used as normal GPIO by cutting the solder bridge on SB1 and SB2, and soldering SB3 and SB4. 

Regards,

Priyanka

[VADIM KADUKOV]

Hi, 

thanks, but this not help. When i trying to write "1" to P0.00 or P0.01, i have "0" at pins

to use P1.02 as gpio help CONFIG_NFCT_PINS_AS_GPIOS=y in prj.conf 

[Priyanka]

Hi,

I am sorry but I cannot understand your query.

1. Did you try following the instructions in the link that I had provided earlier? Even after that it's not successful?

2. Do you wish to use P1.02 also?

Regards,

Priyanka