This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Error when bootloader with Master Control Panel

Hi,

I 'm using MCP v3.9.0.6, softdevice v7.2.0 and pca10003 board.

After load bootloader program to board. I use MCP to load application for it. In MCP, I choose device dfu_targ, connect, discovery services, and DFU choose my .HEX file. But after upload firmware 100%. MCP shows error and I can not solve this image description

image description

Thanks and regard

Parents

0 Hung Bui over 8 years ago

Hi Trananh,

Could you let me know the SDK you used ? The MCP v3.9.0.6 may not be compatible with the bootloader in the older SDK. You can have a look at this blog post.

If you are using SDK v7 or v8, and still have the issue, could you provide the MCP log, (click File -> Log) as well as a sniffer trace ?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Hung Bui over 8 years ago

Hi Trananh,

Could you let me know the SDK you used ? The MCP v3.9.0.6 may not be compatible with the bootloader in the older SDK. You can have a look at this blog post.

If you are using SDK v7 or v8, and still have the issue, could you provide the MCP log, (click File -> Log) as well as a sniffer trace ?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data