This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Error when bootloader with Master Control Panel

Hi,

I 'm using MCP v3.9.0.6, softdevice v7.2.0 and pca10003 board.

After load bootloader program to board. I use MCP to load application for it. In MCP, I choose device dfu_targ, connect, discovery services, and DFU choose my .HEX file. But after upload firmware 100%. MCP shows error and I can not solve this image description

image description

Thanks and regard

Parents

0 Hung Bui over 8 years ago
@Trananh: It seems that I also got the same issue with MCP 3.7.0 that the new Jlink driver is not compatible. I guess you can try either:

Install older version of Jlink here. Maybe you can try with v4.5. (Make sure you uninstal newer version).

Porting the new bootloader from SDK v7.0 back to SDK v6.1. It shouldn't be too difficult since they use the same softdevice.

Note that new nordic development kit is recommended (with revision 3 chip) because when you go into production, you will most likely have to use revision 3 chip. And with the new DK kit you can use the latest SDK v9.0
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Hung Bui over 8 years ago
@Trananh: It seems that I also got the same issue with MCP 3.7.0 that the new Jlink driver is not compatible. I guess you can try either:

Install older version of Jlink here. Maybe you can try with v4.5. (Make sure you uninstal newer version).

Porting the new bootloader from SDK v7.0 back to SDK v6.1. It shouldn't be too difficult since they use the same softdevice.

Note that new nordic development kit is recommended (with revision 3 chip) because when you go into production, you will most likely have to use revision 3 chip. And with the new DK kit you can use the latest SDK v9.0
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data