• State Not Answered
  • Locked Locked
  • Replies 19 replies
  • Subscribers 63 subscribers
  • Views 4581 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 108391
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Error when bootloader with Master Control Panel

trananh

Hi,

I 'm using MCP v3.9.0.6, softdevice v7.2.0 and pca10003 board.

After load bootloader program to board. I use MCP to load application for it. In MCP, I choose device dfu_targ, connect, discovery services, and DFU choose my .HEX file. But after upload firmware 100%. MCP shows error and I can not solve this image description

image description

Thanks and regard

Parents
  • 0

    @trananh: I found a small trick could help MCP 3.7 works.

    First make sure you have flashed the firmware located in C:\Program Files (x86)\Nordic Semiconductor\Master Control Panel\3.7.0.8488\firmware to the dongle you have. Then click File -> Option -> Serial port , selcect Show all serial ports After that you should be able to select the COM port matching with the dongle virtual COM port. Then you can use it.

    Regarding "Porting the new bootloader from SDK v7.0 back to SDK v6.1": I meant you can copy the bootloader for SDK v7.0 and use it with SDK v6.1, some modification needed. But I think it should not be too complicated.

Reply
  • 0

    @trananh: I found a small trick could help MCP 3.7 works.

    First make sure you have flashed the firmware located in C:\Program Files (x86)\Nordic Semiconductor\Master Control Panel\3.7.0.8488\firmware to the dongle you have. Then click File -> Option -> Serial port , selcect Show all serial ports After that you should be able to select the COM port matching with the dongle virtual COM port. Then you can use it.

    Regarding "Porting the new bootloader from SDK v7.0 back to SDK v6.1": I meant you can copy the bootloader for SDK v7.0 and use it with SDK v6.1, some modification needed. But I think it should not be too complicated.

Children
No Data
Related