Fanstel EV BC840M UART not working

[Prathik]

Hello. I had worked on nrf52840 development kit with BLE UART code(pin 6 and 8 as Tx and Rx). I used the same code on Fanstel EV BC840M board. I changed the Uart pins to 9 and 10. I also tried with different gpio's. But its not working. Please let me know how I can fix this. Thank you.

[Vidar Berg]

Hello,

Can you provide a link to a datasheet or user manual for this EV board? We use pin 6 and 8 on the DK, but not sure what Fanstel uses. Also, pin 9 and 10 are by default configured as NFC inputs: NFCPINS

Best regards,

Vidar

[Prathik]

Thank you for your response Vidar Berg. It worked on Fanstel just like nrf52 DK board. I had not configure the proper pins, So it didn't work. After I used the pins 7 and 8 it worked. Thank you.