• State Verified Answer
  • Locked Locked
  • Replies 8 replies
  • Subscribers 67 subscribers
  • Views 10851 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 100849
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

nRF24L01+ mesh network

Arunkumar Dhananjayan

I am trying to implement a mesh protocol using the nRF24L01+ transceiver.

After reading the product specification, I have concluded that the Enhanced ShockBurst cannot be used to implement a mesh, as the node has to have a fixed role viz. PTX or a PRX. Am I right?

Will I be able to implement a mesh network by disabling the Enchanced ShockBurst and using it in the ShockBurst compatibiltiy mode?

Parents
  • 0

    Some more clarifications on the question:

    I was assuming that a particular node can only be either in the PTX or PRX mode.

    Is it possible to have all nodes in PRX mode and whenever, a node needs to transmit, make it switch to PTX mode? How long does it take to make this switch? Will there be any other side effects if a node constantly switches to PTX mode and back again to PRX mode?

Reply
  • 0

    Some more clarifications on the question:

    I was assuming that a particular node can only be either in the PTX or PRX mode.

    Is it possible to have all nodes in PRX mode and whenever, a node needs to transmit, make it switch to PTX mode? How long does it take to make this switch? Will there be any other side effects if a node constantly switches to PTX mode and back again to PRX mode?

Children
No Data
Related