App crashes after manual disconnection from mobile application.

[AthulValsan]

There is a custom bootloader in the flash having a address of 0x27000 immediately after the soft device occur, the bootloader code jumps directly to our beacon application having a flash address of 0x30100. The beacon application works fine.

Then we connected a mobile with the beacon and disconnected. After disconnection we didn't see any beacon broadcast from the device(nrf52833). Please help me to find the reason.    

[Simonr]

Hi

I think we need some more information on what your application actually does upon a disconnect event. What SDK are you using for development, the nRF5 SDK or the nRF Connect SDK?

What happens in your application when the BLE_GAP_EVT_DISCONNECTED or the disconnected() callback is trigged (depending on the SDK you're using)?

 

Best regards,

Simon

[AthulValsan]

hi,

I am developing ibeacon application using nRF5 SDK with nrf52833 board. It will advertise beacon data every 100ms. it supports connection from central device. 

In our case mobile app is central device.

I am connected to my ibeacon using  mobile app. After forceful disconnection from mobile app. our nrf52833 based beacon application disconnected successfully. After few seconds of disconnection i can't see broadcast from beacon. This issue happens when I am combining custom bootloader. Without bootloader there is no issue after forceful disconnection.