nRF9160 SLM Data mode control

[Michal Mühlpachr]

Hi,

NCS v1.9.1 SLM, 115200 baudrate

SLM reports default timelimit for exit seqence 0ms, minimal 2ms.
After setting 40ms timelimit, SLM reports minimal timelimit 32ms.

Why default is 0ms ?

Why minimal timelimit differs ?

Regards,
Michal

[Jun Qing ZOU]

This is a bug introduced in NCSv1.9.0. 0 means <time_limit> is not set yet. In reality SLM always applies <minimal_time_limit> if <time_limit> is not set, meaning <time_limit> 0 is allowed. <minimal_time_limit> is calculated based on baudrate, while <time_limit> is an adjustable value.
Fix is added here

[Michal Mühlpachr]

Thank you.

Regards,
Michal