not advertising when i configure RX pin to other GPIO in UART example

[sagarnayakm]

Hello,

In my project i am using nrf52810 with my custom board for pushing data to UART so i have used UART example code for this but UART pins are connected 20 (TX), 25(RX) since i have changed pin number in the firmware to 20,25 after this BLE Tag is not advertise . i don't know what is happening i can't able to push the data to UART. Is there any problem please let me know.

thank you.

[Kenneth]

Hi, I suspect that the RXD pin is floating, if it's floating the UART will receive framing error and the code typically asserts, can you make sure RXD is pulled high?

Kenneth

[sagarnayakm]

Hello,

Thanks for your reply first and 

Kenneth said:

I suspect that the RXD pin is floating, if it's floating the UART will receive framing error and the code typically asserts, can you make sure RXD is pulled high?

Ok. i will try and let you know the status 

thank you.