motion sensor data is not showing using thingy 91 for Asset Tracker ?

[Mohit Nama]

hello sir ,

 i am using thigy91 board and uploaded the asset tracker application code from  ncs sample code . ii am getting humidity data on my azure cloud .but there was no data available regarding motion sensor.

1. Is there any way for test motion sensor data ,any AT command for it for LTE monitor.

2. Is I need to solder SB6 and SB5 pin to get data.

[Albrecht Markus Schellenberger]

Hello Mohit,

1. Is there any way for test motion sensor data ,any AT command for it for LTE monitor.

2. Is I need to solder SB6 and SB5 pin to get data.

Referring to the Data sampling section of the Asset Tracker v2 documentation:

The accelerometer available on the Thingy:91 needs detailed tuning for each use case to determine reliably which readings are considered as motion. 
This is beyond the scope of the general asset tracker framework this application provides. 
Therefore, the readings are not transmitted to the cloud and are only used to detect a binary active and inactive state.

Regards,

Markus

[Mohit Nama]

sir, thank you for prompt response, you shared very useful information .

but 2. point is not answered , I am still confused about soldering. SB6and SB5  .

can you give the possible reason  for not getting motion data?. or any trouble shooting process via hardware check or  through programming .

[Albrecht Markus Schellenberger]

Hello Mohit,

Mohit Nama said:

but 2. point is not answered , I am still confused about soldering. SB6and SB5  .

Referring to the Motion Sensors chapter of the Thingy:91. So the answer to your question is: Yes, you have to solder them for the described use cases.

Mohit Nama said:

can you give the possible reason  for not getting motion data?. or any trouble shooting process via hardware check or  through programming .

I’m not sure if I fully understand this question. Can you elaborate?

Regards,

Markus

[Mohit Nama]

sir, i want to send motion reading on azure cloud.

I want to know that how i can take data from motion sensor , what steps i have to follow to got that. 

[Mohit Nama]

sir , please suggest me how to get data of Temperature , humidity ,and motion  . using asset tracker code for thingy 91 .