ADVERTISING STOP IN DEBUG MODE

[Brandon_sbz]

Hi all,

I have a problem when I try to debug nRF52832 target. The nRF52832 chip is advertising properly but as soon as I enter in debug mode, advertising stops. There is no reset triggered and I don't use any breakpoints while debugging, just logging some data.

This issue only occurs on my new custom board, on 2 other custom board I don't have this problem...

Does anyone have any idea what is causing this problem?

Thanks in advance! 

[Simonr]

Hi

Then this RF connector must be causing some interference on the board I think. As there aren't any error messages from the device when advertising and there is no reset triggering, I think it is operating as it should, but you don't see any BLE activity because this RF connector is messing up the radio signals somehow. Can you show me a (high-res) picture of the board with this RF connector? There might be that it requires additional tuning to work optimally.

Best regards,

Simon