Hello all,
for the last few weeks I am trying to workout the i2c protocol with the sensor and the nrf52dk , so far none of the solution that I have considered work. More can be seen here: https://devzone.nordicsemi.com/f/nordic-q-a/84978/twi-reading-and-writing-basics/363652#363652
I am thinking can the speed of the processor be too fast for the sensor prototype, like the wires to the board may be too long, for example, for example, the same prototype works on the Arduino's Atmel omega just ok...
Therefore, to test this out my question is, how to reduce the speed of the i2c to less than 100kHz and how to reduce the speed of the processor? Indeed, if you have other suggestions please do not hesitate.
Thank you in advance, looking forward to your suggestions, ideas, how to tackle this further.
Best.