This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

GPSMON and nRF52840 Connectivity Bridge

Hi,

I'm trying to use the GNSS application for the nRF9160 to compare GPS antenna performance. There is a Linux utility, GPSMON, that I'm trying to use to display side by side performance of different GPS receivers, and identical receivers with different antennas. GPSMON will recognize the output of the nRF9160 on a development board but not the output of an nRF52840 programmed with the connectivity bridge software. There doesn't seem to be any difference in the data when viewed in terminal programs.

I'm looking for any ideas on why the connectivity bridge software doesn't work in this scenario?

JT

Parents
  • John_Turner said:
    As far as I can tell everything on the Nordic side is working as expected. I'm going to assume that the issue is with the GPSMON code so I think the case can be closed.

    Thanks a lot for your feedback, John! 

    My personal recommendation would be to investigate the GPSMON side as well. But feel free to create a new ticket if that does not give the desired results :-)

    Cheers, 

    Markus 

Reply
  • John_Turner said:
    As far as I can tell everything on the Nordic side is working as expected. I'm going to assume that the issue is with the GPSMON code so I think the case can be closed.

    Thanks a lot for your feedback, John! 

    My personal recommendation would be to investigate the GPSMON side as well. But feel free to create a new ticket if that does not give the desired results :-)

    Cheers, 

    Markus 

Children
No Data
Related