• State Not Answered
  • Replies 8 replies
  • Subscribers 94 subscribers
  • Views 1395 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 290958
Options

nRF9160 SiP custom board

Cristina

Hi,

I want to use the nRF9160 SiP to connect via NB IoT to AWS IoT server but I don't want to use any SDK, I only want to use AT COMMANDS, there is some process that I could follow?

I've been using the nRF9160 DK and programmed the SLM sample to connect to AWS server using MQTT AT commands, if I want to implement such sdk where does the program been stored? on the SiP or do I have to program it on another module?

Parents
  • 0

    Hello ,
    To run or accept external AT Commands to the nRF9160, you will initially have to program the nRF9160 SiP with the Nordics at_client sample application. And of course, to do so, you will have to use the nRF Connect SDK. The firmware will then reside on the nRF9160 that will accept the AT commands and execute them.

    Once the above is done, you can then use an external MCU to read/write AT commands via the UART to the nRF9160 and use it as only a cell modem.

    Does this answer your question?

Reply
  • 0

    Hello ,
    To run or accept external AT Commands to the nRF9160, you will initially have to program the nRF9160 SiP with the Nordics at_client sample application. And of course, to do so, you will have to use the nRF Connect SDK. The firmware will then reside on the nRF9160 that will accept the AT commands and execute them.

    Once the above is done, you can then use an external MCU to read/write AT commands via the UART to the nRF9160 and use it as only a cell modem.

    Does this answer your question?

Children
No Data
Related
Terms of service