This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Using SEGGER RTT on an external nRF chip

I'm using DK as the programmer connected (via Debug Out) to a naked nrf51 module (Rigado BMD-200). I can program it via DK, but RTT doesn't work (no output in J-Link RTT Viewer). Am I doing something wrong, or is it just impossible to do it this way?

Top Replies

Stefan Birnir Sverrisson over 9 years ago +1

Hi andrey I tested RTT on my two PCA10028 boards and it seems to be working fine. I connect Debug out port of PCA10028 board 1 to a Debug in port of PCA10028 board 2. I can see printed RTT data in the…

Parents

0 andrey over 9 years ago

There was a problem in code preventing RTT from working.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Stefan Birnir Sverrisson over 9 years ago in reply to andrey

@andrey Thank you for your feedback. Can you share what was wrong in your code that prevented RTT from working?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Stefan Birnir Sverrisson over 9 years ago in reply to andrey

@andrey Thank you for your feedback. Can you share what was wrong in your code that prevented RTT from working?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data