nrf52832 not auto repairing

[xtian]

tried the proximity example to check pairing/auto-repairing using PCA10040 board. currently having not auto repaing after we power OFF/ON the device.

we are planning to develop a device using gatt service to get the status of a GPIO. is there a way to auto_repair the device with phone? currently using IOS

thanks

[Kazi Afroza Sultana]

Hello,

Have you followed the <InstallFolder>\examples\ble_peripheral\ble_app_proximity example properly?  From the documentation, you should follow the testing part ((https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter.sdk5.v15.2.0%2Fble_sdk_app_proximity.html)) properly specially the bonding part where you have pair 2 devices via ''perform bonding''. The you have to wait until the bond is established before you continue. Then you have to Observe that the BSP_INDICATE_CONNECTED state is indicated (on board LED1 is on).

Thanks.

Best Regards,

Kazi Afroza Sultana