recovery mode in mcuboot image hash:unavaliable

[wangrj]

board 5340dk_cpuapp

sdk v2.0.0

hello world sample

push button SW1 and push reset button that go to mcuboot

can't upload new image to slot1

and the hash  is unavaliable

i use guiconfig configurate and save to file :

CONFIG_MCUBOOT_SERIAL=y
CONFIG_MCUBOOT_INDICATION_LED=y
CONFIG_MAIN_STACK_SIZE=10240
CONFIG_LOG_DEFAULT_LEVEL=0
CONFIG_NCS_MCUBOOT_IN_BUILD=y
CONFIG_PARTITION_MANAGER_ENABLED=y
CONFIG_FPROTECT=y
CONFIG_FLASH=y
CONFIG_CBPRINTF_NANO=y
CONFIG_LOG=y
CONFIG_LOG_MODE_MINIMAL=y

how to use recovery mode  in mcuboot   , rather than application.

[Raoul]

Hi wangrj,

I'm looking at your issue! I'll try to get back to you soon, hopefully tomorrow.

Best regards,

Raoul

[wangrj]

ncs v2.0.0.0

i view the code that button trigger recovery mode in mcuboot  

it seems no support to check hash value 

so i use CONFIG_BOOT_UPGRADE_ONLY=y to solved it

Raoul thank you very much!

[Raoul]

Hi wangrj,

I'm glad you found a solution!

Yes, it seems that list images and some other "less important" mcumgr commands are not compiled into the MCUboot partition, to keep the partition as small as possible. But based on your picture, the transfer of your image seems to have completed to 100%.

Have a nice day!

Best regards,

Raoul Pathak

[wangrj]

may i ask you another question , how to build a CDC recovery mode project?

In ncs\bootloader\mcuboot\boot\zephyr  ,there are two file "usb_cdc_acm.overlay" and "usb_cdc_acm_log_recovery.conf" seem  can't let project build suceess. is there a perfect build way?

[Raoul]

Hi wangrj!

If I'm not mistaken you've created a new ticket for that question ( can't use cdc recovery mode in mcuboot), that's great.

I'm going to be out of office for 1 week, so I suggest that you just focus on this issue over there.

Best wishes,

Raoul