How to change Output Radio Amplifier Power and then test the byte error, package error of nrf5340?

[Cong Ma]

Hello, I have managed to get two NRF5340s linked and measured their throughput. Now I need to change their Output Radio Amplifier Power to test again.  And then I also need to test the byte error and package error of the nrf5340.How can I do this?

many thanks.

[Jared]

Hi there,

Are you using the BLE or the radio directly?

Have you seen our radio test example?

regards

Jared

[Cong Ma]

I use the bluetooth/thoughput sample. Do I need to add or change some codes?

[Jared]

Hi there,

You need to debug your application and see what is actually passed to set_tx_power() when you run the program. In the HCI_power_control example you'll see that the handle type is passed as first, the handle itself as second, and third the power level which should be a int8_t. 

For example:

Cong Ma said:

this is com listener looks like. I dont know why.

Also, this looks like an entirely new error. Was this first introduced when you added set_tx_power()? 

regards

Jared

[Cong Ma]

This happens on the com listener every time I add set_tx_power(), I use this board as the master board for bluetooth communication and then it appears to connect and then display some parameters and then disconnect.

Many thanks 

Cong

[Jared]

Did you check which parameters you pass to set_tx_power()?

[Cong Ma]

Yes, it doesn't look as if it's the same as the screenshot you posted, is it a problem with the parameters?

Is it a problem with different versions?

Many thanks

Cong

[Jared]

Hi,

What parameters are you passing set_tx_power() when you try to write to it? Can you specify all the 3 parameters that you pass to the function? 

Cong Ma said:

Set-Variable : Cannot find a positional parameter that accepts the actual parameter "err:".
Location Line:1 Character: 1
+ Set Tx power err: Neg5dBm reason 0xFB

This seems to indicate that one of the parameters that you pass is not correct.

regards

Jared