How to reset a remote node using the Mesh provisioner example in NCS 1.9.1

[Susheel]

Hello Experts,

I am trying to realize the following sequence

1) Reset button pressed on the remote node.

2) Remote node intimates the Mesh provisioner node by sending a message to it.

3) Mesh provisioner node initiates a node reset procedure remotely.

Could you please guide me through the process? I am using the nrf52832 DK as a provisioner and nrf52840 Dk as the sensor server/sensor client.

Thank you!

[Elfving]

Susheel said:

The remote node does reset and starts to broadcast unprovisioned beacons.

At least that sounds promising.

Could you try increasing the timeout using bt_mesh_cfg_cli_timeout_set and see if that makes a difference?

Regards,

Elfving

[Susheel]

Hello Elfving, I have increased my configuration timeout but, I still see -116 being returned. 

I have found that my remote node in fact resets due to a hard fault when it receives the reset command. Any idea why?

P.S sorry for the delayed responses. I am juggling tasks at the moment.

Update: for the fault, I just had to increase the stack size of the mesh_adv thread. But, I still see the timeout returned for the function call even after increasing the cfg_cli timeout to 4 times the original. Please advice.

[Elfving]

Susheel said:

P.S sorry for the delayed responses. I am juggling tasks at the moment.

Hehe likewise, sorry about the delay.

Have you gotten any further with this? I understand that if it works, it works, though getting a timeout error was a bit surprising. 

The config client shall receive a Config Node Reset Status message after sending a Config Node Reset.

With the hardfault being fixed, is there any other relevant log coming from the node that is being reset? If the node fails to send the status message (and it still resets) it should be observable in the logs.

Regards,

Elfving

[Susheel]

Hello Elfving,

Apologies for the delay. I was able to get some logs from the provisioner. Looks like the reset status message with opcode 0x804A does get published from the remote node (address 0x006 in the attached pic) to the provisioner (address 0x0001) after receiving the reset request with opcode 0x8049. But the timeout occurs before the status gets received. 

I tried increasing the cfg_cli timeout by multiplying it by 100 times. You can see the time difference in the log.

Please advice.

[Elfving]

I am trying to find what is throwing 116 here. I assume you've added the log for these lines in the SDK? 

Could you show me where, so that I know where the 116 is coming from.

Regards,

Elfving

[Susheel]

Hello Elfving,

Sorry about the delay again. 

This error seems to be coming from line. Please suggest.