nrf_drv_spi_transfer always returns all 0's from device.

[davidb]

I'm using SDK 14.2.0.

I'm trying to read the device ID register from ISM330DHCX accelerometer this way:

ret = nrf_drv_spi_transfer(&m_spi[Instance], &reg_addr, 1, read_temp, length + 1);

In the function nrf_drv_spi_transfer() NRF_DRV_SPI_USE_SPIM and SPIM_PRESENT are both true and nrfx_spim_xfer() is called.

I can't figure out if nrfx_spim_xfer() is using the parameters passed by nrf_drv_spi_transfer() above. Is it using reg_addr? Is it using the correct chip select?

My spi config:

const nrf_drv_spi_config_t spi_ism330_config =
{ \
.sck_pin = NRF_GPIO_PIN_MAP(0, 8), \
.mosi_pin = NRF_GPIO_PIN_MAP(0, 6), \
.miso_pin = NRF_GPIO_PIN_MAP(0, 5), \
.ss_pin = NRF_GPIO_PIN_MAP(0, 7), \
.irq_priority = SPI_DEFAULT_CONFIG_IRQ_PRIORITY, \
.orc = 0xFF, \
.frequency = NRF_DRV_SPI_FREQ_125K, \
.mode = NRF_DRV_SPI_MODE_3, \
.bit_order = NRF_DRV_SPI_BIT_ORDER_MSB_FIRST \
};

I have tried to read the device ID register of a different device using this same procedure and it also returns 0x00, 0x00. I have a feeling there is some sdk config issue.

1258.sdk_config.h

[Simonr]

Hi

Are you using a development kit or a custom board for testing this application? By default the pins P0.05 - P0.08 are used by the UART for logging in most of our example projects, so there might be a conflict with the pins you're using. Can you try either using some other pins for SPI or make sure that the UART isn't configured to also use pins P0.05-P0.08?

Best regards,

Simon

[davidb]

I changed gpio pins as follows:

.sck_pin = NRF_GPIO_PIN_MAP(1, 11), \
.mosi_pin = NRF_GPIO_PIN_MAP(1, 13), \
.miso_pin = NRF_GPIO_PIN_MAP(1, 10), \
.ss_pin = NRF_GPIO_PIN_MAP(1, 12), \

Did not help. Still receive 0x00,0x00 from device.