Angle of arrival application to see switching on nrf52833 board

[yalcinPak]

Hello , I have a problem on angle of arrival application to see switching nrf52833 board

I use nrf52833 dev board. I use 2.0.0 as sdk version. I use nrf/samples/Bluetooth/direction_finding_connectionless_rx .

I can’t see overlay-aoa.conf in Kconfig. There is aod-overlay.conf. So I only choose boards\nrf52833dk_nrf52833.conf.

I flashed my nrf52833 board. But I couldn’t see switching at pin3,pin4, pin28 or pin29 using oscilloscope.

 ---------------------------------------------------------------------------------

Nrf52833dk_nrf52833.conf file is at below

---------------------------------------------------------------------------------

Nrf52833dk_nrf52833.overlay file is at below

---------------------------------------------------------------------------------

I was expecting to see overlay-aoa.conf file. Because I use rx . Am I wrong ?

There is overlay-aod.conf file and you can see at below

---------------------------------------------------------------------------------

Prj.conf file is at below

Here in general

[yalcinPak]

Thank you very much all of you. I can see switching. I was expecting continuous high switching. But now I understood. I can see switching in every 2,4 seconds.

[JlaielMS]

Hallo,

I'm facing the same issue you had. Could you let me know how you solved it?

 

[Amanda Hsieh]

This case was created two years ago. Please create a support case for your own.