Initiating Hardware Reset Through Software on 9160

Hello,

I want to build in a reset function for handling certain error states on the 9160DK running nRF Conenct 1.6.0.  In the datasheet it appears that nRESET is p0.32 and is active low.  I checked in the .dts file and saw that there was not a pin 0.32 and also no reset device bound, so was not sure how to go about pulling the pin low to initiate the reset.

Is it possible to initiate a reset this way, and if so how do I go about it?  Do I need to create a custom device in the .dts file assigned to p0.32 and then pull it low?  Is it possible to pull a pin low without binding it in the device tree?  

Thanks!

Related