nRF52833 Coded PHY

[Louw]

Good day

I am currently developing a system using the nRF52833. A nRF peripheral device needs to be connected to both a mobile app and a nRF central device. The software on the peripheral currently is able to connect to both the mobile app and central, using 1MBs PHY. I need the peripheral device to be able to connect to the mobile app using 1MBs PHY and to the central device using Coded PHY.

I have been struggling with this for a while now and any help would be appreciated. I have read through the forums and any examples I was able to find, but I am still unable to resolve the issue.

Could you please provide me with a list of things to change/add on the Nordic side of the project, specifically for the nRF52833.

Kind regards

Details:
nRF52833 on a custom PCB
nRF5 SDK version 17.1.0
Soft devices s140-7.2.0 and s122-8.0.0
The software is adapted from the BLE UART examples in the SDK

[Louw]

There is no more logging after "Debug logging for UART over RTT started". When debugging the code, I'm able to step through everything without any errors.


If I comment out (lines 629 - 631 in my code):
// init.config.ble_adv_primary_phy = BLE_GAP_PHY_CODED;
// init.config.ble_adv_secondary_phy = BLE_GAP_PHY_CODED;
// init.config.ble_adv_extended_enabled = true;
The code works fine again, immediately connects.

00> <info> app_timer: RTC: initialized.
00>
00> <info> app: Debug logging for UART over RTT started.
00>
00> <debug> nrf_ble_gatt: Requesting to update ATT MTU to 247 bytes on connection 0x0.
00>
00> <debug> nrf_ble_gatt: Updating data length to 251 on connection 0x0.
00>
00> <info> app: Connected
00>
00> <debug> nrf_ble_gatt: Peer on connection 0x0 requested an ATT MTU of 247 bytes.
00>
00> <debug> nrf_ble_gatt: Updating ATT MTU to 247 bytes (desired: 247) on connection 0x0.
00>
00> <debug> nrf_ble_gatt: ATT MTU updated to 247 bytes on connection


I don't think the advertising_start function is changing anything
static void advertising_start(void)
{
uint32_t err_code = ble_advertising_start(&m_advertising, BLE_ADV_MODE_FAST);
APP_ERROR_CHECK(err_code);
}