After the ota is done when I reboot the board it will run old image again.

[Joyop]

Hi,

Today I found that after I OTA my board, it runs well at first. But when I reset it, it will run old image again.

Before this OTA, my board has gone through many OTAs, and this has never happened.

The difference between the previous OTA and this OTA is that the pm_static.yml in this project has been modified, resulting in a different flash map. Is that the reason?

NCS version: 1.9.1

Looking forward to your reply.

Joyop

[dejans]

Hi,

Do you use DK or a custom board? Which chip do you use on your board?

Best regards,
Dejan

[Joyop]

Custom board. The chip is nrf52840.

[dejans]

Hi,

What is general structure of your application project?

What do you want to upgrade using OTA?

Best regards,
Dejan

[Joyop]

What do you mean of 'general structure'?

I want to update my firmware. New firmware integrates NVS module.

In my opinion, it seems nothing to do with the app but the MCUboot . I don't know if my intuition is right or not.

Looking forward to further discussion.

[dejans]

Hi,

Joyop said:

What do you mean of 'general structure'?

I was referring to the directory structure of your application.

Are you trying to upgrade only the application, bootloader or both?

Best regards,
Dejan

[Joyop]

Only the application.

Is it even possible to upgrade bootloader?

[dejans]

Hi,

MCUboot can be added as upgradable bootloader. Please take a look at adding upgradable bootloader.

Best regards,
Dejan