Current consumption is different between ampere meter measurement and source meter measurement using PPK II

[Tai]

Hello everyone,

I'm testing current consumption of nRF52 dev KIT (PCA10040). The test application is a BLE application. I tried with two methods for measuring current consumption (Ampere and Source meter). However, I got a significant difference between two methods.

The setups of both methods for current consumption are attached below as well. I've followed several video tutorials for this setup.

Using ampere meter, I got every low current consumption as shown in the following figure (147 uA for BLE advertising and 225 uA for BLE connection initialization). In contrast, using source meter method (set 3V to external supply) I got very high current consumptions with > 1.6 mA for BLE advertising and > 3.7 mA for BLE connection initialization. 

Are two methods supposed to give the same current consumption? Or please let me know if I have any wrong setup for this. Thanks!

[Simonr]

Hi

First off, make sure the DEBUG flag isn't set in the preprocessor settings, and then open the dropdown folder where Debug is set now, and you should be able to select "Release" or "Common" there instead.

Best regards,

Simon